What If My Studs Are Too Far Apart?

How do you mount a TV off the center studs?

If a stud does not fall dead center to where you want to hang your television, you will need to mount a piece of scrap plywood on two studs in order to create a solid surface for your hardware mount..

How many studs do you need to mount a TV?

two studsDo not use hollow-wall anchors as they cannot support the weight of TV wall mount brackets and the television. Once you’ve picked an ideal location for hanging a TV on the wall, run a stud finder along the top of the paper. Locate the two studs in your wall that will support your TV.

Can you mount a TV off center?

Yes, the TV can be mounted off-center. The extent and amount that you can adjust it from side to side is limited to the width of the mounting holes on your specific TV & the total width of the actual wall plate attached to your wall.

Can you mount a 60 inch TV on drywall?

To answer your actual question. The extra layer of drywall is not a problem as long as the bolts are all long enough. Do not mount your expensive TV to the drywall regardless of what kind of fastener you use. The correct answer is to attach it to the structural part of the wall – the studs.

How far away are studs from each other?

24 inchesYou may wonder, how far apart are studs in my home? They’re always spaced either 16 or 24 inches on-center (measured from center to center) along the wall and run between the floor and ceiling.

Is it safe to mount a TV on one stud?

If your TV is being mounted in a corner or on a wall where centering is not a priority, a fixed single stud TV mount will do the job. If you are wall mounting your TV in a small area or on a small wall where not centering the TV will be obvious, use an adjustable single stud TV mount.

Can you mount a TV with only 2 screws?

Take the maximum weight rating of the mount, divide by two, if it’s still more than your TV’s weight, you are fine. If it isn’t… you are fine, but you might eventually crack the back of the TV if you tilt or move it a lot (swivel mount). If it’s a flush mount though, you’ll be more than fine with 2 screws.

How accurate is a stud finder?

Electronic stud finders are more precise than magnetic ones. They feature either an LED screen or indicator lights that can pinpoint the edges of a stud and the exact center. High-quality electronic stud detectors can detect studs located deeper in the wall than what a magnet can detect (up to 1-1/2 inches).

Is there a stud finder that actually works?

Hanson 03040 Magnetic Stud Finder. After 30 hours of research and testing against five other magnetic stud finders, we found the C.H. Hanson to be reliable, durable, and accurate, and we also like it because it doesn’t need batteries or any kind of calibration.

Are studs every 12 inches?

If you don’t have a stud finder, there are several methods that can be effective in finding studs. When a home is framed, the wall studs are usually spaced 16 or 24 inches apart. If you start in a corner and measure out 16 inches and you don’t find a stud, you should find one at 24 inches.

What to do when you cant find a stud?

A third method is to use a strong magnet to locate the nail or screws holding the drywall to the studs. You can knock on the wall to find the general stud location then confirm using the magnet. Hard drive magnets are perfect for this (yes, I know the magnet in the picture isn’t a hard drive magnet, haha).

What is the strongest drywall anchor?

Traditional metal toggle bolts are the strongest of the bunch, but they’re not the simplest to install because they require drilling a hole that’s approximately three times wider than the diameter of the bolt (necessary to insert the anchor).

Will drywall anchors hold a TV?

Use a stud finder to locate the studs in your wall to determine where you can hang the TV. Do not attempt to use drywall anchors to hang it. Eventually, the anchors will get pulled through the drywall and your TV will end up on the floor.

Why do stud finders not work?

1) Check Your Battery. If your stud finder worked previously, but no longer seems to work, about 9 times out of 10, the problem is a weak battery. You may swear that the battery is still good, but it’s not. … Compared to garage doors and many other devices, stud finders require a very strong battery.

How much weight can a stud hold for TV?

Zach Eyman: “A good rule of thumb is 80 pounds for a single stud, but a specific mount’s specifications should always be followed.” Eighty pounds, as we’ll see later, is pretty much everything below 60 inches.

How much weight can stud hold?

between 80 and 100 poundsA screw in a stud can hold between 80 and 100 pounds. Be sure to distribute the weight across as many as you can. The easiest way to increase the amount of weight a screw in a stud can hold is to simply double up.

Can you mount a TV on drywall without studs?

A toggle anchor or a toggle bolt is a great way to hang a TV without studs. You’ll need to use a hollow wall anchor that looks similar to a regular screw, with a butterfly toggle at the end. Once you’ve placed them in the wall, they’ll attach to the back.

Can you mount a TV without a stud finder?

Unfortunately, depending on your living space and the construction of your home, the wall that you choose for your TV may not have studs. The good news is that you can still mount your TV despite the hollow walls with Mount-It’s No Stud TV Wall Mount that hangs on your wall like a picture frame.